Meraki MX /31

SOLVED
Mosquitar
Here to help

Meraki MX /31

Hi All,

 

I cant find an answer to this, but does anyone know if the Meraki MX supports /31 subnets on the WAN uplink interfaces?

 

Thanks

1 ACCEPTED SOLUTION
PhilipDAth
Kind of a big deal
Kind of a big deal

8 REPLIES 8
PhilipDAth
Kind of a big deal
Kind of a big deal

It does not.

That's a shame, I will need to use /30s instead.

 

Thanks for the response Philip

Has there been any progress on this in the last 5 years? We just got a new fiber connection installed for one of our clients, and they only provided a /31 static IP block. Any idea if this configuration is now supported?

PhilipDAth
Kind of a big deal
Kind of a big deal

A low comment says they were able to configure this, but did not test it.

Owen
Getting noticed

The release notes for version 14.24 say it is possible. I have not tried it though.

Hi Owen,

 

Ahh yes. I will try and test this when I can. Thank you.

 

  • Added support for assigning a /31 subnet to the MX’s uplink via the local status page. The IP address assigned to the MX must be the higher of the two available IP addresses in the /31 subnet

Any luck with /31 mask test on the WAN interface of the MX?

I have tried to configure it in an inactive WAN interface through the dashboard (uplink tab) and it accepts it, but haven't yet tried on an active interface. We are using MX version 14.53.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels