Comes here often


Hi, I was hoping I could get some advice on an issue we are experiencing with a Meraki MX67C-WW device. We have it connected to an internet circuit and 4G. When we see the primary internet connection fail, traffic is then re-routed over the 4g secondary circuit as expected. 


The issue is we do not see the traffic fail back to the primary internet circuit when it comes back online; should this automatically failover?


Not sure if this is may be a hardware issue, and if so would like to know if it is possible to generate a "show tech" equivalent for TAC support.


Any help/suggestions would be much appreciated 🙂





Here to help

Yes, traffic should automatically fail back to WAN 1 when it is up. You may need to change WAN failover behaviour to Immediate rather than Graceful (Connection Monitoring for WAN Failover - Cisco Meraki)


Other that that, reach out to support as you have already suggested. No show tech required, just give them a ring and they will troubleshoot with you!

Kind of a big deal
Kind of a big deal

As is said above, check your WAN failover behaviour.

As a side note, if the network is templated, you can't change the behaviour. It is hard configured to graceful.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.