I have my MX100 with another MX100 in Spare mode and I have proceeded to make the following configuration:
Wan 1: 172.20.2.0/24 ISP 100 MB
Wan 2: 192.168.0.0/16 ISP 300 MB
In these MX I have configured 2 lan:
- Id lan 1 External 192.168.51.0/24
- Id lan 20 Internal 192.168.52.0/24
I have configured the lan 20 output rules for Wan 1 and lan 1 for wan 2
Everything works perfectly, lan 20 communicates with the servers that are behind 172.20.2.0 and when I do speed test it shows me the 2 speeds of the routers according to which lan is connected.
The problem comes when I want to configure Active directory with Meraki, I go to SD-WAN> Active Directory and configure everything leaving the configuration like this:
Short domain Ip server Admin.domain password state
Contoso 172.20.2.X XXX XXXX XXXX accept
I find the groups, but the problem is when I want to save the configuration, I get the following error:
There have been errors when saving this configuration:
The IP address 172.20.2.X is not on a configured local subnet, nor a remote subnet on the VPN.
Can someone help me?
Thanks so much!
First of all, thank you for answering.
In rules of the firewall I have gone to I don't appear any rule configured in the matter, I leave capture so that you see the problem in the matter
If anyone else can help me, I'd be very grateful.
The AD is at 172.20.2.20 (ip distributed by the AD) and users will connect to 192.168.52.0/24.
There are flow preference rules configured and I want users to log in by AD in meraki
the 172.20.2.20 is a subnet that enters through wan 1 and there is no rule defined for this in the section of SD-WAN--> Vlan and address.