MX 18.103 Release, One New Feature, Multiple Fixes
New features
Added support for configuring VPN exclusion rules for non-Meraki VPN peers.
Bug fixes
Resolved an issue that could result in drops of cellular connectivity when IPv6 was in use with some cellular networks.
Added firmware support for LLDP on LAN ports of MX95, MX105, MX250, and MX450 appliances
Performance improvements for MX250 and MX450 appliances
Corrected an issue that could result in EBGP peering instability when 1) a large number of AutoVPN routes were being advertised via EBGP and 2) the MX appliance had a reduced WAN MTU.
Resolved an issue that resulted in IPv6 traffic being dropped when sent over an IPv4 tunnel formed with a non-Meraki VPN peer.
Fixed an MX 18.1XX performance regression on MX64(W) and MX65(W) appliances.
Corrected an issue that could result in traffic to non-Meraki VPN peers being incorrectly NAT’ed when the peer was configured using an FQDN as opposed to an IP address.
Resolved several rare issues for MX67C, MX68CW, and Z3C appliances that could result in the integrated cellular modem being unable to properly initialize after an upgrade from MX 16 was performed.
Fixed an MX 18.1XX regression that could result in MX appliances configured in HA or passthrough mode to lose WAN connectivity.
Corrected an issue that could result in a device reboot of MX appliances.
Corrected an issue that could result in the global IPv6 address being unreachable to some LAN clients when the IP address was obtained via SLAAC on a cellular uplink.
Resolved a rare issue that could result in traffic being misclassified by NBAR.
Stability improvements for VMX-L appliances deployed in the Umbrella Cloud.
Known issues
After making some configuration changes on MX84 appliances, a brief period of packet loss may occur. This will affect all MX84 appliances on all MX firmware versions
Due to an MX 15 regression, the management port on MX84 appliances does not provide access to the local status page
Client traffic will be dropped by MX65(W), MX67(C,W), and MX68(W,CW) appliances if 1) The client is connected to a LAN port with 802.1X authentication enabled and 2) The VLAN ID of the port is configured to 16, 32, 48, 64, 80, 96, 112, 128, 144, 160, 176, 192, 208, 224, or 240.
There is an increased risk of encountering device stability and performance issues on all platforms and across all configurations.
