Meraki

NexFirmJC

Why is it that one of the best devices (MX68, 75) for small businesses don't support LACP or LAG?

Who can we send an email to to implement this, even if they increase the cost by a couple of hundred?s

RWelch

Meraki MX appliances do not run LACP or any link aggregation protocols (intentionally by design).

If you wanted to make it a request you can Give your feedback (previously Make a Wish)

If you found this post helpful, please give it Kudos. If my answer solves your problem please click Accept as Solution so others can benefit from it.

alemabrahao

This is the document that contains the information described.

https://documentation.meraki.com/SASE_and_SD-WAN/MX/Design_and_Configure/Configuration_Guides/Networ...

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

PhilipDAth

I'm with you on this one! I suspect it is a limitation of the switch hardware.

ffiol

Hello, we encountered the same problem and found this workaround.

How to connect the Meraki MX to MS switches – Karstens Cyber-Fi Blog

Tested and proven to work wonderfully.

I hope this helps.

Regards.

alemabrahao

It's not an workaround, it's the design proposed by Meraki.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Meraki

Community

LACP/LAG

LACP/LAG