How can i enable vpn subnet translation feature on Meraki MX64?

[munaf]

How can i enable vpn subnet translation feature on Meraki MX64?

[Jwiley78]

You should see the option appear once you enable Site to Site VPN.  The options will show just below on the same page.

[munaf]

i cannot find the option even after setting up site to site vpn

[Jwiley78]

I may need to see if I can find a MX64.  I guess it's possible that it's not available on that model.

[munaf]

yes but cant find it

[PhilipDAth]

You need to open a case with support to get this feature enabled.

[Jwiley78]

Good to know.  We have a few networks that use it but I did not set them up that's why I was sure why it couldn't be found.

[Mayur_Gadhvi]

VPN subnet translation feature is ideal for deployments where the same subnet is used in multiple locations and each of those subnets needs to have access to the site-to-site VPN. 

This feature is not limited to any Model but it is just not available on the dashboard by default, to enable this feature, you need to open the case with Meraki support to enable this feature for your organization.

[rhbirkelund]

But, afaik, VPN Subnet translation is not available on Non-Meraki peers...