Am I the only one that color codes of mx devices (we mainly use mx68cw) are bit annoying. We have network of 165 SD-WAN devices, and little over 100 of them is using cellular connection (4G) as the primary/only connection to internet. They work quite fine, but all these sites are marked 'yellow' color (instead of green) on the map and as their current health status. I understand that if someone use fixed WAN connection and cellular is secondary/backup connection, this would be the desired color, but in our case where the scenario is different, the color codes are confusing. I Would like to see configuration option where I could select which is the primary connection, and then if it drops to secondary (or no connection), color would be yellow (or red in no connection situation).