Showing results for 
Show  only  | Search instead for 
Did you mean: 

Cisco jabber with MX

Here to help

Cisco jabber with MX



We have a case that need is to allow Cisco Jabber to be accessible from out side of the network. For that, we’re following the cisco guide.


the idea is to allow Jabber clients register to the on premise cisco call manager.

The optimum scenario (in other firewalls) , is to configure the Edge Expressway server as a DMZ client behind the firewall so that whenever the public IP of the firewalls is requested, it’s forwarded to the DMZ client (the edge expressway server). Unfortunately, the Meraki MX does not have a ready to use DMZ client straight config. So we need to configure port forwarding as per the attached requirements from Cisco.



When we try to do it, the MX refuse to save and says the source ports and the dist. Ports should be in the same range!


How do you suggest we resolve this issue knowing that the ISP only provided one public IP (used for the MX wan port) with no extra spare public IP to be used. 


Appreciate your inputs... 

Head in the Cloud

Re: Cisco jabber with MX

I think the problem you're experiencing is that in the "Public port" you're putting in the "Source Port". The "Public Port" is actually the "Destination Port" of the traffic hitting the "Public IP" of the MX. Heres an idea, e.g for the last rule; You'll just then have to follow the same concept for all the other required rules.


Description  - Uplink x - Protocol - Public port - LAN IP - Local Ports - Allowed remote IP's

XMPP - Uplink 1 - TCP - 522 - LAN IP of Edge Expressway - 522 - Public IP of remote hosts (If a variety of ranges you could use any)


Effectively if you allow "any" this will allow all incoming traffic with the destination port 522 to be forwarded to the Edge Expressway. Try and limit it to the remote locations via public IP's.

Eliot F | Simplifying IT with Cloud Solutions
Found this helpful? Give me some Kudos! (click on the little up-arrow below)
Kind of a big deal

Re: Cisco jabber with MX

Also note that the second to last rule for udp/1024-65535 is not actually for the server so there is nothing to enter.

Kind of a big deal

Re: Cisco jabber with MX

I believe your forwarding rules (under Security Appliance/Firewall) should look something like this (where is your server):


Screenshot from 2017-12-14 00-09-19.png

Here to help

Re: Cisco jabber with MX

@PhilipDAth  thanks .. We did as per the picture.. Jabber registered and able to make calls but Not able to hear the other end ( & the other end cant hear us as well) .. are there any other RTP ports needed for this or other ports to be forwarded? 




Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.