Hello,
We currently have the following setup and are looking into using Azure Firewall.
MX250 STS VPN that is connected to a vMX100 in Azure. Can we put an azure firewall in-line with this setup?
Can anyone share their experiences?
Thanks,
Derek
@Derekjr : The vMX is a virtual MX - Which is an SDWAN and a firewall device. Well you can add azure firewall in-line of course.
https://www.youtube.com/watch?v=MljINqgmDkM
@Inderdeep So does it make sense to use the MX as a firewall? I am new to Meraki. I was asked to setup an azure firewall but if using the vmx makes more sense I can do that.
@Derekjr : yes
https://meraki.cisco.com/product/security-sd-wan/virtual-appliances/vmx-small/
https://documentation.meraki.com/MX/MX_Installation_Guides/vMX_Comparison_Datasheet
so this is where i would set up the rules?
So will i be able to use it as a firewall if it is any of these modes?
So I think I have wrapped my head around this a bit more. I have set up Client VPN on the vmx100. I don't want to set up a split tunnel, so I will add the azure firewall as the next hop so it will route internet traffic and internal traffic.
Does this sound correct? I know the vmx100 does not support full tunnel.