Can you configure a GS switch with a static Management IP and gateway - if so how?

RichardTyrrell
New here

Can you configure a GS switch with a static Management IP and gateway - if so how?

I can find documentation regarding configuration once the device is working but if you needed to place a switch on a network without DHCP and configure it with a static IP/Gateway so it can reach the internet in the first place? The static would have a path to the internet. 

If not can you place it on a network where it picks up DHCP then change the management IP /Gateway to a static through the GUI?

2 REPLIES 2
Xydocq
Building a reputation

Since I don't own a GS-device, I'm not sure if you can do that.

 

The GX20 can be accessed thru a LAN connection directly (prior or after initial setup), by entering the local IP in a browser. Username would be the Serial-Number of the device, password isn't required. This leads to a basic setup-page where you can set Internet-Connection-type and port-management (disable/enable).

 

Maybe the GS offers something similar?

Soichiro-Ono
Getting noticed

Hello.

 

Please refer this section.

Meraki Go - Local Status Page - Cisco Meraki

>Configure: This tab allows editing the uplink IP address settings.

 

Regard,

If you found this post helpful, please give it kudos.
If my answer solved your problem, click "accept as solution" so that others can benefit from it.
有用な回答だと思われる際にはkudoをクリックして頂けると幸いです。
回答があなたの問題を解決した場合、accept as solutionをクリックしてください。