Documentation Digest: June 21st - July 21st

CameronMoody
Meraki Employee
Meraki Employee

Documentation Digest: June 21st - July 21st

CameronMoody_0-1649974201283.png

 

 

Hi Community,

 

Below are the most important changes to our documentation between June 21st and July 21st:

 

Adaptive Policy Overview

Change: Added WiFi 6E APs to list of supported MRs.

 

Client Balancing

Band Steering

Wireless Mesh Networking

IPv6 Support on MR Access Points

Change: Added information on feature behavior with MR 29.x.

 

Enhanced Staged Upgrades

Change: New Article.

 

Apple Device Enrollment Program (DEP)

Change: Updated for new Assign Setting interface.

 

Systems Manager Agent Release Notes

Change: Added release notes for version 3.5.2.

 

Meraki Vision Changelog

Change: Added release notes for up to v1.6.8.

 

Second Generation MV Cameras: Overview and Specifications

Change: Added MV52 to Technical Breakdown table.

 

Multi Network Video Walls on Vision Portal [BETA]

Change: New Article.

 

MT12 Installation Guide - Water Detection

Change: Removed note about rubber caps. New MA-CBL-LEAK-1 don't need them anymore.

Cameron Moody | Product Manager, Cisco Meraki
2 REPLIES 2
Inderdeep
Kind of a big deal
Kind of a big deal

@CameronMoody :thanks for the update 

Regards/Inder
Cisco IT Blogs awarded in 2020 & 2021
www.thenetworkdna.com
MyHomeNWLab
A model citizen

Client Balancing - Cisco Meraki
> Client Balancing Behavior - MR 29.X and Newer Firmware
 
> An AP can only attempt to load balance the client or reject an association request two times for both active and passive client balancing.  
 
I've been waiting for this feature! 😍
 
In high-density wireless environments with many Meraki MRs, Client Balancing may in some cases continue to reject clients.
e.g. The wireless client goes to connect to MR#1 (reject) => MR#2 (reject) => MR#3 (reject) => MR#4 (reject) => MR#1 (reject) ... and so on.
 
It is good that a limit has been placed on the number of rejections.
I hope to improve the wireless environment!
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.