I did an install of 4 APs in one install.
When doing the install, I would have preferred to scan and add the AP to the app before i physically installed it to the ceiling.
However, they all look alike so in order to get correct naming i the app, i had to scan and add them to the merkaki go app when doing the install. I could not pre-load them into the app since it was hard for me to install them at the named location.
I would have preferred to add some sort of unique identifer on the physical devices ( a sticker with a letter or number ) so you can pre-load all the equipment into the meraki go application before doing the installation so you have some sort of control on what accesspoint is installed where
