Retiring Domain Controller(s) - locating hard-coded IPs in Dashboard

RobShort
New here

Retiring Domain Controller(s) - locating hard-coded IPs in Dashboard

I am retiring some old (out-of-date) domain controllers and need to remove any hard-coded instances of their IP addresses from the Dashboard.

 

I've gotten the usual spots - DNS entries in DHCP, WiFi/APs, switches, VPN, etc. Anyone know of other locations in the Dashboard I should check before I retire the old DCs? (I'm already planning the old "Temporarily shut down the DCs and see what breaks" method, but wanted to catch as many hard-coded entries as I could before I try that.)

 

Appreciate any and all throughs/suggestions. 

2 REPLIES 2
UCcert
Kind of a big deal

Off the cuff, what about the DNS entries under your device LAN management settings for switches, APs etc? Are they pointing at your DC’s for DNS?

Darren O'Connor | uccert.co.uk
https://www.linkedin.com/in/darrenoconnor/

I'm not an employee of Cisco/Meraki. My posts are based on Meraki best practice and what has worked for me in the field.
UCcert
Kind of a big deal

Any Radius related config? Some sites run Radius in the same server as their DC.  Any Umbrella setup/integration?

Darren O'Connor | uccert.co.uk
https://www.linkedin.com/in/darrenoconnor/

I'm not an employee of Cisco/Meraki. My posts are based on Meraki best practice and what has worked for me in the field.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.