Monitoring Meraki

Sonirak
Just browsing

Monitoring Meraki

So we are starting to convert over to Meraki. Has anyone been able to monitor Meraki devices for port/uplink bandwidth using SNMP? I have tried standard MIBs and the cloud controller MIB and I just can't get it to work. I can get the ping sensor and with the cloud controller MIB I can get each device, but no bandwidth sensors. Any advice or help?

3 REPLIES 3
Larry_Woods
Meraki Employee
Meraki Employee

This post doesn't apply to this specific sub-forum.  I would put it here:  https://community.meraki.com/t5/Full-Stack-Network-Wide/bd-p/network-wide 

Thank you, @Larry_Woods, for the helpful pointer! @Sonirak I went ahead and moved your post to the most relevant forum where the community will be better able to assist in answering your question. Welcome to the Meraki Community, btw 😃

BlakeRichardson
Kind of a big deal
Kind of a big deal

@Sonirak What monitoring software are you using? 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.