Delay IP Configuration

Solved
ham737
Here to help

Delay IP Configuration

Is there a way to set a time that a Meraki Switch will go from a DHCP to a hard coded IP? I am swapping out old switches and I want the new Meraki's to have same IP but can't take the old ones down without the new ones up. My thought is if I can swap the IPs and then turn off the port on the Meraki that is connected to the old switches. Bad idea possibly... just brainstorming here.

 

thank you! 

ham737
1 Accepted Solution
BrechtSchamp
Kind of a big deal

In most cases the IP is just used for management purposes. Can't you use a temporary address, take out the old switch and change the IP after that? That change should be bumpless. Or do you have routes pointing to its IP address?

View solution in original post

2 Replies 2
BrechtSchamp
Kind of a big deal

In most cases the IP is just used for management purposes. Can't you use a temporary address, take out the old switch and change the IP after that? That change should be bumpless. Or do you have routes pointing to its IP address?

PhilipDAth
Kind of a big deal
Kind of a big deal

If this is for the management IP - why bother making it static at all?

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.