Meraki

Tu__Nguyen

Thanks for your ref. After searching, it is clearer that each AP model has specific power limitation (only show when manual setting), as below: Thanks

Tu__Nguyen

Thanks for expanding with related informatio.

Tu__Nguyen

We are installing MR. 56 APs for a high ceiling room (11 meters H), that required maximizing transmit power as much as possible. However, the actual power (~13 dBm) were not reflected as setting (target power: 27 - 29 dBm) as picture below. Does any one experienced the same issue and can resolved? Thanks Andrew.

Tu__Nguyen · ‎Mar 21 2024

The problem is 'source' organization is per-device license, and 'destination' organization is co-term license. License type is different, so I am not sure is it possible or converting need to be done. Thanks !

Tu__Nguyen · ‎Mar 18 2024

We need to move devices from per-device licensing org to another co-term licensing org for our customer. Just don't know the impact and procedure. Kindly share your experience or suggestion about this. Thanks

Tu__Nguyen · ‎Mar 17 2024

Our customer required bandwidth limit for a specific 'localnet' is 100Mbps. But in the sharping rule dashboard, the bandwidth limit only allow 5Mbps (simple) and 10Mbps (detail mode). How can I increase this maximum limit? (self-configuration or support help might required?) Thanks.

Meraki

Community

About Tu__Nguyen

Tu__Nguyen

Community Record

Badges

Re: Radio transmit power were not increased as setting.

Re: Radio transmit power were not increased as setting.

Radio transmit power were not increased as setting.

Re: How to move device from per-device licensing org to another co-term lic...

How to move device from per-device licensing org to another co-term licensi...

How to increase the bandwidth limit in traffic sharping to more than 100Mbp...

Re: Radio transmit power were not increased as setting.