Not sure if this still is an issue but for anyone still using Sky I got it mostly stable by creating a whole new wireless network. Enabled Discoverable mode Set it to NAT Allow devices to discover each other (device to device comms set to ON) - this should turn off Guest mode WPA 2+3 then put all the sky boxes on that wifi, it mostly held up but had its tantrums.   Just junked the whole lot and went to Apple TV boxes with Now TV and all the other streaming services - no issues with the Apple hardware on Meraki Go...flawless   ... View more

gutted! aside from a few quirks this has to be my favourite bit of SME kit for those low scale deployments that don't need all the cool stuff in full fat Meraki with all the extra licensing costs. i think an option with a lower hardware and little or no licensing costs would be preferred in these scenarios...as its hard to justify the huge price gap to full-fat Meraki gateways. HPE still offer the lightweight Aruba AP solution but no gateways (that i would trust versus anything Cisco - aside from the odd high CVSS vulns)   Gonna miss the gateways as they were again a good option to get clients on platform without the huge cost of licences and complex configs ... View more

Ok, so an update here.   The issue seems almost certain to be an issue with the Meraki Go AP itself.   The Sky Q boxes are designed to transmit on both 2.4 and 5Ghz, although it seems they prefer 2.4Ghz on first bonding.   With the GR10 hosting the SSID, the sky box connects, then after approximately 5-7 minutes the SkyQ boxes disconnect, claiming they cannot connect to the network. The only way to re-establish is to wipe and reconfigure the boxes and rejoin the SSID with the password. After a further 5-7 minutes the Sky Q boxes lose their connection again.   This clearly suggests the Sky Q box performs some action that causes it to become disconnected from the GR10.   Host the same SSID (and same password) on a Cisco SMB (RV Series) Router/FW/AP, same IP range, same VLAN and the connection remain stable and doesn't drop.   GR10 is on Channel 11 & 44 but the RV is running 6 & 36    All other devices are super stable on the GR10 (iphones, microsoft devices etc...) it is just Sky Q boxes.   Without the capacity of the Meraki enterprise devices to perform packet capture, manually adjust channels etc... can't diagnose further.      ... View more

Thanks Lee,   Already done that - no reply yet ... View more