Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About WALVAREZ

Re: LAN VLAN AND MPLS

by in Security & SD-WAN
a week ago
1 Kudo
a week ago
1 Kudo
Hello, I was analyzing and  the network announced in the MPLS is 172.19.249.128/27 as the  graphic show, so I need to make NAT Inside over any ip in this range,( for example: 10.67.103.0/24 -->  172.19.236.128/27) in order to be able to go out with that IP to the MPLS network.  Is this configuration possible or what should I modify to have communication with the server 172.18.10.10 in the MPLS and also have Internet through the WAN1 port??  Thanks  for yout reply. ... View more

LAN VLAN AND MPLS

by in Security & SD-WAN
2 weeks ago
1 Kudo
2 weeks ago
1 Kudo
Hello   Guys,  I have a topology of MPLS ( two routers in VRRP), one switch to VRRP, and one Cisco Meraki MX67 whit one Internet channel in the WAN port and MPLS Channel in PORT 2 interface IP (172.19.236.214) VLAN 118,  in my LAN  172.19.249.128/27 reach the network  172.18.10.10/24  up, all fine,  but since the ips range has been exhausted ( 172.19.249.128/27 only 30 ips), I have decided to change to one with a 24 mask ( 10.67.103.0/24). According to the graph,  Is there any way to have network 10.67.103.0/24 and from there reach network 172.18.10.0/24 without making configurations in the MPLS routers. That is, with some type of masking or some internal NAT technique in the Meraki MX67?   For example,  the ip 10.67.103.66 is routed with ip 172.19.236.214 and reaches the network 172.18.10.0 or no is possible?     ... View more
© 2024 Cisco Systems, Inc.