MR56 access points & MS250/350 switches POE

Just browsing

MR56 access points & MS250/350 switches POE

Can we connect a MR56 Access Point to existing Meraki MS350-48LP or MS250-48LP switches using the switches POE capability, wasn't sure it would have enough power to service it?


Thanks in advance

2 Replies 2
Getting noticed

Sure you can we have the same switches 

but as @rwiesmann says not on all ports 


If your switches are stacked, you can split the load between the switches so you don't go over the power threshold for the LP model switches.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.