Layer 3 firewall rules on Group policy (from appliance)

[GoOn]

I built a new group policy with these layer 3 rules:

Then I applied it to my device opening clients page, then my device page, and selecting it (I found it with its' name + "(from appliance)") in the Group policy dropdown menu and then save.

If now I reopen my device page, I can find the new group correctyl applied, clicking on "Show details" I view the rules I posted here.

I waited 5 minutes, but I'm anyway still able to ping 192.168.100.83, and also 192.168.1.45

So, what's wrong???

[ww]

What is your client ip and subnet mask?

[GoOn]

192.168.3.5 and 255.255.255.0

[ww]

Your routing vlans are configured on the mx?

Did you disconnect/reconnect your client to the network? 

https://documentation.meraki.com/General_Administration/Tools_and_Troubleshooting/Troubleshooting_Gr...

[GoOn]

Your routing vlans are configured on the mx?

=> where can I find this info?

Did you disconnect/reconnect your client to the network? 

=> my (the source) yes, the destination not!

[Bruce]

What firmware version are you running on the MX?

[GoOn]

MX 15.42.3

[cmr]

@GoOn do you have the VLAN interfaces set up on the MX or is it in single LAN mode:

 

[GoOn]

On the source I have some VLANs configured, on the destination (the IP I ping) not, single LAN