Hello,   I have a MX FW which only had one vlan on it. It as connected to a Meraki switch, which had all the vlans configured on it. As part of a security audit I was told to move the vlans to the FW.    I have now moved the vlans to the FW. I allowed 'all' vlans on the trunk hich has a native vlan 200. The two ends of the trunk have IPs so it acts like a layer 3 device, in that there is a default route on the switch which points to the FW end of the trunk. The FW has no routes other than local subnets that it detected itself.    I am connected to a port on the switch - I have picked up a DHCP IP in the correct vlan but I get no internet on my laptop now and I cant ping the DG despite the FW being wide open rule wise.    What am I missing? Is it better to just have the subnet configured on the switch and point everything else to the FW as before?  Thanks in advance ... View more

Hello,   I have a Meraki MX84 that is now going to be directly connected to an internet line directly via the Internet 1 port. Unfortunately I have only been given one usable IP. I have another firewall that requires outbound internet. My question is how can I setup what was basically a PAT interface on other cisco devices (such as an ASA).    Do I just add the outside interface of the FW into a LAN interface on the MX and it will just work? Or do I need to setup a PAT (which I cannot find any documentation for).    Thanks in advance Brenden  ... View more

Hello,   Anytime I make ANY config changes on my Meraki MX84 version 16.16, the device loses internet connectivity. The power light goes orange and then I need to reboot the device.    This surely cant be the expected behaviour? Its driving me nuts. It also means I can only do changes in the office.    Any advice would be appreciated.    thanks Bred ... View more