Meraki

Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 

About Takongs

Re: Trouble Shooting VPN Tunnel on a MX65 with multi WAN Connections

by in Security & SD-WAN
‎Apr 7 2022 5:37 AM
‎Apr 7 2022 5:37 AM
Remotely rebooted the MX 65 again late last night and the tunnel back back up it looks like running some more test this morning to confirm. Its weird that the reboots I tried before that did nothing for it but that one did.  ... View more

Re: Trouble Shooting VPN Tunnel on a MX65 with multi WAN Connections

by in Security & SD-WAN
‎Apr 6 2022 7:39 PM
‎Apr 6 2022 7:39 PM
As soon as I take WAN 1 down I loose communication to the DC. The DC is a Meraki MX 100 and it is sitting behind a firewall not sure how to tell what mode it is to be 100% with you but I will look . This morning around 1am it just looks like the tunnel for WAN 2 drops off in the attached picture below. ... View more

Trouble Shooting VPN Tunnel on a MX65 with multi WAN Connections

by in Security & SD-WAN
‎Apr 6 2022 2:49 PM
‎Apr 6 2022 2:49 PM
Looking for some help trouble shooting an issue at a location with 2 ISP connected to a MX 65. One connection WAN 2 is 500m Symmetrical and the other WAN 1 is 5M Symmetrical.   My primary link is set to WAN 2 and all of my locations VPN tunnels and outside internet traffic are using that link but the site to site VPN tunnel going to my DC it is using WAN 1 and I cant figure out why. Is there a good way in the dashboard to understand why it is taking WAN 1 when the performance stats are so much worse it all most treating it like WAN 2 link is down and force the VPN traffic to use WAN 1 which is causing performance issues. This all start happing around 1 AM this morning it was working fine before that.   ... View more
© 2024 Cisco Systems, Inc.