We currently have a handful of MS-120 switches (using L3 switching) in the field that need the uplinks reconfigured for a new Internet provider. Currently, port 1 on the MS is acting as an uplink port for the existing provider. We would like to connect the new provider on another port (port3) and swap over to that new port once it's verified working, with a minimum of downtime to our customers. Both uplink connections require different static IP addresses. I am looking for a known procedure to make this change happen remotely via the dashboard. So ... a few questions... Can I have more than one uplink live at the same time ? Can I connect the new link to the switch and verify its operation without taking the old uplink down? If the answers to the above questions are yes, can I then just change the default route on the L3 page of the dashboard to point to the new provider instead of the old provider and see virtually no downtime? Or does this change require someone to be physically at the location to config the local dashboard?   Any help would be appreciated   ... View more