Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
About Francois
Francois
Just browsing
Member since Jan 21, 2018
Jul 14 2020
Community Record
5
Posts
0
Kudos
0
Solutions
Badges
Jan 23 2018
12:52 AM
What about this considering none of the two sites use a static IP address? https://documentation.meraki.com/MX-Z/Deployment_Guides/SD-WAN_Deployment_Guide_(CVD) If manual NAT traversal is selected, it is highly recommended that the VPN concentrator be assigned a static IP address. Manual NAT traversal is intended for configurations when all traffic for a specified port can be forward to the VPN concentrator. What would be the best setting then according to you ?
... View more
Jan 23 2018
12:51 AM
What about this considering none of the two sites use a static IP address? https://documentation.meraki.com/MX-Z/Deployment_Guides/SD-WAN_Deployment_Guide_(CVD) If manual NAT traversal is selected, it is highly recommended that the VPN concentrator be assigned a static IP address. Manual NAT traversal is intended for configurations when all traffic for a specified port can be forward to the VPN concentrator. What would be the best setting then according to you ?
... View more
Jan 23 2018
12:12 AM
Thanks for the input. It is a VPN between a Mx60 and a z1 both using broadsband acces with variable public ip address
... View more
Jan 23 2018
12:11 AM
I played around a while with disabling and enabling the VPN back, in H&S or 1x Hub and the other Spk. I suspect the site that faced the connectivity issue is now having stability problem with the VPN registery... Reboot the applicance is a good idea, thanks.
... View more
Jan 21 2018
12:02 PM
Hello friends, I am trying to set back up a VPN that were running ok until I faced a internet connectivity issue on one of the two sites. Now it is fixed but I can't make it run fine anymore. The VPN tunnel itself seems to be up and running but the remote LAN status on each site stays in red in the VPN status menu / "1 site to site peer" and of course no end to end ping works. Any idea on the way to troubleshoot this? Thanks in advance guys, François
... View more
© 2025 Cisco Systems, Inc.
