Meraki Community
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Show  only  | Search instead for 
Did you mean: 
  • About MooMee

About MooMee

Re: AP connectivity issues (<1 min)

by in Wireless
‎Sep 13 2019 3:47 PM
‎Sep 13 2019 3:47 PM
Went back and forth with Cisco tech on 2 different cases over 2 months. The solution for me was on our Sonicwall; UDP/ICMP flood protection. Disabled both, problem solved.    This only happened when wireless users began to logon at a high rate. This is at a high school so at 7:30AM the issue would begin and at 2:45PM it would stop. All of Cisco's infinite wisdom couldn't help so i figured it out by pcapping everything under the sun...lol. I can tell you it was a happy day! ... View more

MS250 disconnects for 1 to 2 minutes multiple times during the day

by in Switching
‎Jun 18 2019 8:27 PM
‎Jun 18 2019 8:27 PM
I get a stream of disconnects starting when users get on the network in the morning (7:30am) and then they taper off toward noon. I have checked with our ISP, Comcast EDI and all is well. I have run multiple wireshark caps searching for anything out of place. I opened a case with 3 different meraki engineers and couldn't help. There are no disconnects after 3PM and all through the night until the next morning when no users are present. The switches are less than 25% utilized at peek periods. These switches are new for us so i have them trunked into an established HP switch on one single port. I also have 1 MR53 connected to a single port. Everything is connected to the proper vlans. A point of interest... i have one of the new MR53s connected to just the HP switch and it still shows a disconnect when the MS250s and the  MRs connected to the MS250s disconnect. Anything that is meraki is affected by something on the network whether its connected to meraki or hp switch.    ... View more
© 2024 Cisco Systems, Inc.