Meraki

Community

About nnvt

Re: MS120 Uplink vlan no connection

by in Switching
‎Dec 13 2018 7:53 AM
‎Dec 13 2018 7:53 AM
@NolanHerring wrote: How is the port on that switch configured? Try removing the VLAN on the switch port configuration. Just delete 1 and hit save. Report back your results. The uplink port on the switch is set to trunk (native vlan 1, allowed vlans: all). I can't seem to remove the vlan from the uplink configuration (invalid vlan specified). ... View more

MS120 Uplink vlan no connection

by in Switching
‎Dec 13 2018 7:43 AM
‎Dec 13 2018 7:43 AM
Hi!   I have a pfsense router with a vlan configured on port 3. My MS120 switch is directly connected to this port.   My pfsense vlan settings are: Interface 3 (Port 3): Status: Enabled No IP assigned   VLAN 1 (native on interface 3): Status: Enabled IP: 10.20.2.1/24     Via the local access page I configured the switch to match the pfsense settings: IP: 10.20.2.4 VLAN: 1 Mask: 255.255.255.0 Gateway: 10.20.2.1 DNS: 8.8.8.8   Unfortunately, the light on the switch remains orange and my pfsense router does not see it. When I connect the cable coming from the router to my Mac and create a new virtual vlan interface with tag 1 and the same ip/mask/gateway/dns as the switch, it connects just fine.   Not sure why it's not working on the switch as my pfsense vlans seem to be configured properly.   Any ideas? ... View more
© 2024 Cisco Systems, Inc.