Gear: MS225-24   I have ports 9 & 10 aggregated and working with my file server.  Been doing fine no issues.  I added a NAS and set it on port 13 & 14 and aggregated those ports. When I aggregated ports 13 & 14 I noticed that 9 & 10 shut down for a second.  Now the switch shows port 9 & 10 as my NAS and ports 13 & 14 as my file server. I turned off port aggregation on 13 & 14 and the switch shows my file server on port 9 & 10 as it's supposed to.  I have moved the NAS to other physical ports ( 11 & 12) and each time I enable more than one set of aggregated ports, all aggregated ports go down for a few seconds and the switch shows the devices connected to the wrong ports.   The pic below is my file server showing on ports 13&14 but it is physically connected to ports 9 &10.  As it's been for a while.  This happens each time I enable new aggregated ports.  The file server shows up on the new ports and the new device shows up on the file server ports.  A little switch-er-oo going on there. (pun intended)   ... View more