Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm unable to attach a service poligy to a FastEthernet port on a 3550. The config is as below. When I apply to the interface as an outbound policy, I get the error " Service Policy attachment failed"?mls qos!class-map match-all Gold match anyclass-...
I'm trying to troubleshoot an ADSL link (BT Broadband in the UK). Hardware is 2600 with WIC1-ADSL. The config is;interface ATM0/0 no ip address no atm ilmi-keepalive pvc 0/38 encapsulation aal5mux ppp dialer dialer pool-member 1interface Dialer1 ip...
To run IGMP snooping on a 3550 in L2 only IGMP snooping must be enabled on switch ports. However until IGMP is enabled on the VLAN interface (this is done by enabling PIM) snooping does not work. also the Cat6000 has an option of enabling a "querier"...
I have a requirement to use T3/E3 speed interface cards. NM-1T3/E3 or NM-1HSSI would both appear to be appropriate. HSSI cards are cheaper, but I was wondering if there are any downsides to using HSSI ? Which would be the best choice ?
I'm looking to use CBFWQ on a CPE device. On the following link there are details on how ATM cell Tax Overhead is calculated. The cisco explanation is not clear.Here is a link to show cisco's calculation; link:http://www.cisco.com/en/US/products/sw/i...
I don't see why you can not configure EIGRP with variance command to allow unequal load balancing. You can change delay/bandwidth to make sure the route is a feasable sucessor then configure variance to enable routing accross the path.
what does the network look like when the link to your primary ISP is failed ? Do you still have the full BGP routing table, is the next hop address correct ? If you log onto an internet route-server does your prefix appear in the routing table ?
it's clear from your config that the class-map is not matching traffic. As the policy-map is attached to a switch port, have you tried basing the class map on mac-address ACL or COS bit ?
