Rough Estimate for MR84 range

route_map
Building a reputation

Rough Estimate for MR84 range

Hi 

 

Can someone assist me with documentation that can give me a rough estimate of the maximum distance the MR84 with MA-ANT-27 antenna can support. And can you suggest a stronger Meraki AP, no generic or other brands

 

I would like to Mesh different sites using the MR84's

5 Replies 5
AjitKumar
Head in the Cloud

Hi @route_map 

I understand this will hard to give an estimate on coverage. The Meraki documentation talks about 100 meter in general.

 

Hope you have referred the following documents.

https://documentation.meraki.com/MR/WiFi_Basics_and_Best_Practices/Access_point_range_and_signal_str...

 

https://documentation.meraki.com/MR/Other_Topics/MR_Access_Point_FAQ

Regards,
Ajit
AjitsNW@gmail.com
www.ajit.network
Nash
Kind of a big deal


@AjitKumar wrote:

Hi @route_map 

I understand this will hard to give an estimate on coverage. The Meraki documentation talks about 100 meter in general.

 

Hope you have referred the following documents.

https://documentation.meraki.com/MR/WiFi_Basics_and_Best_Practices/Access_point_range_and_signal_str...

 

https://documentation.meraki.com/MR/Other_Topics/MR_Access_Point_FAQ


If I remember right, typically speaking, normal-use wireless coverage is typically based around 100m. Simply because everyone was used to 100m thinking from copper ethernet.

 

If one needed longer than that, I would look into equipment designed for long range use. 

NolanHerring
Kind of a big deal

Not an easy question. How are you trying to use this? Outdoor point-to-point/point-to-multipoint links?
Lots of variables involved with this, like tx power, EIRP, fresnel zone, obstructions/line of sight, link budget.
Honestly Meraki 'mesh' isn't super fantastic when it comes to trying to setup a point to point because of its VLAN limitations.

 

If you need multiple VLANs, your going to need to find another solution, UBNT/Ubiquiti has good gear for this, and cost effective.

 

 

https://documentation.meraki.com/MR/Deployment_Guides/Mesh_Deployment_Guide

Ethernet bridging

The gateway access point may be configured to connect to a trunk port and trunk SSIDs to different VLANs. Repeaters will also serve SSIDs trunked on different VLANs. However, only one SSID & associated VLAN may be configured to bridge wired clients across a mesh link on a repeater access point's Ethernet port. A mixture of wired clients and Cisco Meraki access points attached to one MR repeater interface is not a supported deployment configuration. This is due to the auto detection mechanisms that Cisco Meraki access points use to infer when they should function as a gateway or a repeater.

Nolan Herring | nolanwifi.com
TwitterLinkedIn

Plus UBNT has a really awesome tool to help you with outdoor planning

https://link.ui.com/
Nolan Herring | nolanwifi.com
TwitterLinkedIn
Nash
Kind of a big deal

We've got clients using Meraki for p2p bridges and we've got clients using UBNT.

 

The UBNT ones are just rock solid, and vlans! Who doesn't love multiple vlans? I love multiple vlans.

 

I did not love having to explain to a client why he couldn't have his guest network in the remote building, because it was on a different vlan from prod.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels