Posture using Anyconnect

LC_IT
Here to help

Posture using Anyconnect

Hi!

Please, can someone please help me?

It's possible run posture on Windows endpoint connected to MR33 using Cisco Anyconnect + ISE solution?

5 REPLIES 5
Brash
Kind of a big deal
Kind of a big deal

Assuming you're using Anyconnect with a Meraki MX endpoint, no posturing features aren't supported

AnyConnect on ASA vs. MX - Cisco Meraki

Hi Brash.

I don't have MX, just Access Point Meraki MR, ISE and Anyconnect with System Scan module running on endpoint.

alemabrahao
Kind of a big deal
Kind of a big deal

@LC_IT ,

 

Take a look on this article:

 

https://community.cisco.com/t5/security-knowledge-base/how-to-integrate-meraki-networks-with-ise/ta-...

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Hi!

Very good article but it does not mention Anyconnect. 😞

alemabrahao
Kind of a big deal
Kind of a big deal

ISE Posture over AnyConnect is possible just with FTD or Cisco ASA.

I am not a Cisco Meraki employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels