Number of mesh access points in a point to multi-point design

Bastian1
Just browsing

Number of mesh access points in a point to multi-point design

Hi all,
we would like to implement a new design with our MR33 access points.
Thereby several access points (mesh repeater) shall terminate on one gateway access point. Do you have a maximum number of mesh repeaters for one gateway reapter (MR33)?

 

In the Meraki documentation I cannot find any exact information about this.

1 REPLY 1
DJDonovan
Meraki Alumni (Retired)

Hey Bastian!

 

In general, it is recommended you have no more than two Repeater APs attached to a single Gateway AP. It's also in your best interest to have multiple potential gateway APs so that there is not a single point of failure that would knock all of the repeaters offline.

 

Further guidelines regarding a Mesh Deployment can be found in the following documentation: 

https://documentation.meraki.com/MR/Deployment_Guides/Mesh_Deployment_Guide#Deployment_Consideration...

 

Let us know if you have any other questions!

 

-Donovan

~~If you found this post helpful, please give it kudos. If my answer solved your problem, click "accept as solution" so that others can benefit from it.~~

The Meraki ECMS exam is now live! Test your knowledge of Meraki and become an official Cisco Meraki Solutions Specialist. More info on the ECMS exam found here.

For information regarding all of Meraki's training offerings, be sure to check out the Meraki Learning Hub.
Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.