My AP MR33 doesn't Work

SOLVED
Meraki99
Here to help

My AP MR33 doesn't Work

Hello Everyboby, 

 

My issue is below, 

 

I have 10 Meraki Access points that had worked correctely since 2 years ( i have license 3-years term). 

 

Now i have only 9  which work  and the 10th AP is " Unreachable for 14 jours"

 

* The network configuration is correct and it is the same for all AP ( the same network)

 

* When i check the DHCP Server i can see that the getted  a valid and reserved IP Address 

 

*   When  i  do the ping command it doesn't respond  [all network configurations is correct] 

 

* When i  check the cdp neighbor i can see the following : 

 

 

Device ID: xxxxxxxxxxxx [i cached it]
Entry address(es):
IP address: x.x.x.x [ the correct and intented reserved IP Adress]
Platform: Meraki MR33 Cloud Managed AP, Capabilities: Router Switch
Interface: GigabitEthernet1/0/43, Port ID (outgoing port): Port 0
Holdtime : 140 sec

Version :
1

advertisement version: 2
Power drawn: 12.000 Watts
Power request id: 33892, Power management id: 1
Power request levels are:12000 0 0 0 0


Total cdp entries displayed : 1

 

* I try to mark the device as eligible for remplacement, but i get the folling returned message : 

 

" You don't have any devices in your organisation that are a part of a hardware remplacement program"

 

* Also, when i view the access ponts, this AP appear with red color and it state isn't as any cases state : 

 

offline  = 0 , alerting = 0 online = 9 , repeater = 0

 

*** Can somesone already had this problem or could guide me to resolve this problm? 

 

Think in advance and i apologize for my poor english. 

 

 

1 ACCEPTED SOLUTION

Hi, 

 

I went to client site and i reset it to default factory. The problem is resolved and now it wotks Fine 

 

Thank for your help

View solution in original post

9 REPLIES 9
ww
Kind of a big deal
Kind of a big deal

Did you try factory  reset the AP?

@ww Kind of a big deal

 

Not yet. Today i had opned a case  i wait for the Meraki support return and then try to reset it.

 

Thank you

Thank you for your help 

 

I did the factory reset and now it works fine

thanks

GreenMan
Meraki Employee
Meraki Employee

I'd recommend you contact Meraki Support - look under Help > Get help in the Dashboard

 

https://documentation.meraki.com/General_Administration/Support/Contacting_Support

Hi GreenMan, 

 

I did it wright now. 

Thank, 

 

I opned a ticket, reset it to factory dafault and the problem is resolved. 

 

Thanks a lot

GobYuc
Comes here often

change a other IP Static, and reload

Hi, 

 

I went to client site and i reset it to default factory. The problem is resolved and now it wotks Fine 

 

Thank for your help

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels