MR 44 goes into repeator mode

SOLVED
Keith_Li
Comes here often

MR 44 goes into repeator mode

Dear All, 

 

 

          2 of our MR44 AP goes into repeator mode, having check in to meraki switch side and run a cable test button, the pair 4 show open, does it means it is related with bad cable issue ? having checked the Poe useage, it is still under usage, any idea ? 

 

 

 

Port Link Length Status Pair 1 Pair 2 Pair 3 Pair 4

8down48.75 mOKokokokopen

 

 

 

PoE usage

CONSUMPTION
134.9 W / 740 W
BUDGETED
510 W / 740 W
 
 

keith 

1 ACCEPTED SOLUTION
MerakiDave
Meraki Employee
Meraki Employee

Yes @Keith_Li , that is indicating a L1 issue and should look to replace that cable, the AP is unable to make a sufficient wired connection to the LAN and is automatically leveraging repeater mode to keep itself online and keep serving clients.

 

View solution in original post

4 REPLIES 4
MerakiDave
Meraki Employee
Meraki Employee

Yes @Keith_Li , that is indicating a L1 issue and should look to replace that cable, the AP is unable to make a sufficient wired connection to the LAN and is automatically leveraging repeater mode to keep itself online and keep serving clients.

 

Keith_Li
Comes here often

noted, and i will try to ask our cable vendor to check the connection first, thanks for your reply 

EJN
A model citizen

An easy first thing to try is to redo the two ends of the cable (assuming it's a custom length cable). If prebuilt, then just change the cable.

Esteban J Nunez
School and Church
K-12 Education
Keith_Li
Comes here often

problem has resolved by replaced lan cable, thanks 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels