Looking to use umbrella DNS for only a specific WiFi network.
Here is the situation: I am looking to apply different DNS servers (cisco umbrella) only to clients of a certain SSID.
I have seen that this is available using the "Content Filtering" selection of "custom DNS" in the Wireless Access Control page, but this is only available when using the "NAT mode: Use Meraki DHCP" option for client IP assignment.
The issue is that we have VLAN tagging on this traffic to go out a separate MX100 using a secondary internet circuit, so we have to use "Bridge Mode: Make clients part of the LAN" to enable the VLAN tagging.
Do I have to create another VLAN on the MX? (DHCP is handled by the MX currently). Then I would have to adjust the port configuration between the MX and the MS, the ports on both are currently configured as access ports for this VLAN.
Am I missing something here? I thought this was going to be an easy setup.