Clients cannot connect

RVilhelmsen
Getting noticed

Clients cannot connect

Hi,

 

I have a lot of MR18 ap´s running MR 25.9 all connected via PoE injectors.

I believe after upgrading to version MR25.9 some times the AP stops accepting client connections on all configured SSID. That is "802.1X with Meraki RADIUS " and "WPA2-PSK".

 

There is nothing logged in the AP log, but as soon as I restart the AP clients automaticly connects again.

It happens approx. every 2-3 weeks - but not on the same locations and not all locations.

 

Anybody seen this?

 

Regards

Robert

 

2 REPLIES 2
MerakiDave
Meraki Employee
Meraki Employee

I have not seen exactly that issue with MR18s on MR 25.9, but it's worth opening a support ticket so they can scrub your configuration and firmware against known issues.  Since this is sporadic and it's post-upgrade to 25.9, you/they might consider 24.12 as a temporary test, and could do that on a limited scale if needed, just pin a subset of APs in specific locations to an alternate firmware if that might help isolate/troubleshoot.

I´ll open a support ticket. Thanks.

 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels