Being redirected to anti-virus scan

SOLVED
Josh_C
Conversationalist

Being redirected to anti-virus scan

using MR33 AP, have the AP set wide open (Meraki DHCP), still point my clients to scan for anti-virus prior to connection. What am I missing?

1 ACCEPTED SOLUTION
MerakiDave
Meraki Employee
Meraki Employee

Check your SSID settings on the "Access Control" page, if you are using any type of splash page, and if so, there could be a setting for Network Access Control that's enabled to check clients for AV software that you would want to disable.  If you are running the SSID wide open with no splash page and in NAT mode with no content filtering, then something further upstream must be redirecting the clients to the AV scan other than the MR33.  

View solution in original post

1 REPLY 1
MerakiDave
Meraki Employee
Meraki Employee

Check your SSID settings on the "Access Control" page, if you are using any type of splash page, and if so, there could be a setting for Network Access Control that's enabled to check clients for AV software that you would want to disable.  If you are running the SSID wide open with no splash page and in NAT mode with no content filtering, then something further upstream must be redirecting the clients to the AV scan other than the MR33.  

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels