cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Access Points Contacted At Not Working

Highlighted
Conversationalist

Access Points Contacted At Not Working

Hi

 

Anyone else seen where all devices going through an MPLS via Firewall have stopped showing as being Contacted and stop updating their configuration.

 

All Firewall rules as per dashboard are correct

5 REPLIES 5
Highlighted
Kind of a big deal

Re: Access Points Contacted At Not Working

Just the access points?  Setup a port on the switch the same as the AP and try attaching a computer to test/verify to ensure there isn't connectivity issues.  If you cycle one of the APs does it come back online?

Adam R MS | CISSP, CISM, VCP, MCITP, CCNP, ITILv3, CMNO
If this was helpful click the Kudo button below
If my reply solved your issue, please mark it as a solution.
Highlighted
Conversationalist

Re: Access Points Contacted At Not Working

No any Meraki device that goes through our firewall

 

anythingbon broadband has no issues. 

Highlighted
Kind of a big deal

Re: Access Points Contacted At Not Working

From the dashboard go to Help>Firewall Info

 

You'll need to verify those things aren't being blocked somewhere between your devices and the internet.  Likely your edge firewall or MPLS network.  

Adam R MS | CISSP, CISM, VCP, MCITP, CCNP, ITILv3, CMNO
If this was helpful click the Kudo button below
If my reply solved your issue, please mark it as a solution.
Highlighted
Conversationalist

Re: Access Points Contacted At Not Working

appreciative that Been checked by Meraki and Data centre and both confirm all ports are allowed
Highlighted
Conversationalist

Re: Access Points Contacted At Not Working

Was firewall
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.