About the cause of log output

Solved
sandi
Conversationalist

About the cause of log output

Hello
Although it does not occur frequently, the following logs have been logged and an alert email has been sent.

What could be the cause of this log?

 

Although it is an Active / Standby configuration, wan1 is currently Active.

 

***alert mail log***

There have been a total of 2 failover events detected:

At 09:35 AM JST on Dec 15, the security appliance switched to using Internet 2 as its uplink.
At 09:35 AM JST on Dec 15, the security appliance switched to using Internet 1 as its uplink.

***Event log***

Dec 15 09:35:52 Change primary uplink status uplink: 0
Dec 15 09:35:29 Ethernet port carrier change device: port1, carrier: true
Dec 15 09:35:18 Change primary uplink status uplink: 1
Dec 15 09:35:18 Ethernet port carrier change device: port1, carrier: false

1 Accepted Solution
sandi
Conversationalist

This case has been resolved. It was said that the cause was a momentary interruption on the WAN line side.

View solution in original post

1 Reply 1
sandi
Conversationalist

This case has been resolved. It was said that the cause was a momentary interruption on the WAN line side.

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.
Labels