Broken: MV firmware 4.2 on MV12 and people detection via MQTT

PhilipDAth
Kind of a big deal
Kind of a big deal

Broken: MV firmware 4.2 on MV12 and people detection via MQTT

On MV firmware 4.1 on an MV12 I get people detection events via MQTT.

On MV firmware 4.2 on an MV12 I get no people detection events via MQTT.

 

The release notes do say:

"Resolved an issue where too many snapshot API calls could cause camera instability"

But the fix is that you don't get detection events to request a snapshot.  😀

 

Anyone else observed this?

 

 

2 REPLIES 2
PhilipDAth
Kind of a big deal
Kind of a big deal

Yep, borked.

 

MV firmware 4.2 produces this message.

{ ts: 1582602223666, counts: { '': 1 } }

 

MV firmware 4.1 produces this message.

{ ts: 1582602599696, counts: { person: 1 } }

 

Have not observed this yet but haven't had a chance to test.  Will test if time permits and report back  In the meantime please do open a case so Support can flag this and report back to the Eng team - I'm sure this was tested but please report it for investigation, thanks for pointing it out!

 

Get notified when there are additional replies to this discussion.
Welcome to the Meraki Community!
To start contributing, simply sign in with your Cisco account. If you don't yet have a Cisco account, you can sign up.