I was hoping to get some help with setting up a vMX device. I installed it just fine, but cannot seem to get anything to show as UP in my route table. There is zero documentation, that I could fine at least, and my SE didn't really shed any light on the subject, pointing me to the "how to install a vMX in AWS" doc. I need something a lot more in-depth.
FYI - this is setup in Routed mode - already had support help with that.
now for LAN config. when I first opened the page, it had a random network in there, but that is not the network of AWS. Do I change that or leave it? I assumed for MX IP, I use the one that is assigned to the AWS NEI. when I create a static route, do I use the MX IP as the Gateway, next hop or do I use the AWS standard of ##.##.##.1?
I've double checked my AWS routing and SG's to make sure all is open and available.
really frustrated with the lack of documentation with Meraki products. PAN you get 100 pages of detailed configuration, Meraki - here is like 5. good luck. LOL
thanks for any help!!