Need Expertise Guidance : how to install 2 sku of vMX in Active - Active mode in Azure

[Srikanth]

With the limitation of Meraki virtual instance vMX on Azure, and Azure only supporting vMX medium,

 Could you please help on how can we install 2 SKU of Meraki vmx on Azure in Active-Active state to load balance traffic from spokes in multiple regions

this is mainly to utilize the Meraki Auto VPN feature between hub and sites.

Please share your thoughts or experiences on how this can be enabled.

Thanks,

Srikanth

[BrandonS]

You have seen this?

https://documentation.meraki.com/MX/Other_Topics/Deploying_Highly_Available_vMX_in_Azure

[Srikanth]

@BrandonS Thank You for your quick revert, in the diagram shown there the VNET peeing is configured between the primary and secondary hub but is this possible if we install multiple vMX in the same primary hub and how can we establish communication between the vMX and load balance the traffic 

[PhilipDAth]

It will be difficult to do active/active in Azure.

The easiest way would be to create two supernets for your spokes.  Put all the spokes in one Supernet on HubA as their primary, and all the spokes in the second supernet on HubB.  Then you'll be able to use an initial static route in Azure for each supernet.

This article is a close match.

https://www.willette.works/active-active-meraki-sd-wan-headends/