cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Physically label the access points with a unique identifier ( number or letter )

Highlighted
New here

Physically label the access points with a unique identifier ( number or letter )

I did an install of 4 APs in one install.

 

When doing the install, I would have preferred to scan and add the AP to the app before i physically installed it to the ceiling.

 

However, they all look alike so in order to get correct naming i the app, i had to scan and add them to the merkaki go app when doing the install. I could not pre-load them into the app since it was hard for me to install them at the named location.

 

I would have preferred to add some sort of unique identifer on the physical devices ( a sticker with a letter or number ) so you can pre-load all the equipment into the meraki go application before doing the installation so you have some sort of control on what accesspoint is installed where